Look for small led lights on the sensors.
No sensor lights garage door.
Have no power to sensors neither sensor lights are on.
The wires from the terminal block on the opener to the door safety sensors should be connected to terminals 2 and 3 on the opener terminal block.
Light doesn t activate on garage door opener when you cross safety sensor beam chamberlain group products which include the liftmaster chamberlain sears craftsman line of garage door openers have a feature where the opener light will turn on if you cross the safety sensor beam shooting across the opening of your garage door.
First check the sensor lights.
Check if the safety reversing sensors are aligned.
For people who do not know the transmitter has the yellow light and the receiving sensor has the green light.
If you find the lights turned off in one or both the sensors it indicates that there is a problem in power supply.
If they re turned on in both the sensors then there is no issue with the power supply.
One wire from each sensor goes to terminal 2 and one wire to terminal 3.
Have adjusted several times.
A common cause of a malfunctioning garage door sensor is lack of power supply.
On line manual does not specify colors.
Opener works both by remote and wall button to open but will not close by remote and only if hold down wall button until door is fully closed.
If the sensors are not.
If you release button early the door reopens.
Inspect each sensor to make sure the green or red power indicator lights are.
Raise the garage door using the control button on the garage wall or the remote control unit from a vehicle.
The lock button on the door control in on.
The sensors use two photo eye lenses that transmit an infrared beam between them.
If you do not see a solid illumination or your garage door is not working the problem is most likely due to the sensors being out of line.
It sounds like you have a broken wire to the sensor with the green led.
Safety sensors include two mounted sections one on each side of the garage door opening.